Diagnostic Test
WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK FOR AN ACTIVE DIAGNOSTIC TROUBLE CODE (DTC) NOTE:
Diagnose and repair any Passenger Door Module (PDM) DTCs before proceeding with this diagnostic procedure.
- Turn the ignition on.
- With the scan tool, read active DTCs.
Does the scan tool display this DTC as active?
Yes
- Go To 2
No
- The condition that caused this code to set is not present at this time. Check for an intermittent condition by inspecting the related wiring harness for chafed, pierced, pinched, and partially broken wires. Also inspect the related connectors for broken, bent, pushed out, spread, corroded, or contaminated terminals.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
- VERIFY THE PASSENGER DOOR MODULE (PDM) IS ACTIVE ON THE CAN BUS
- With the scan tool, verify that the Passenger Door Module (PDM) is active on the bus.
Is the Passenger Door Module (PDM) active on the bus?
Yes
- Replace and program the Blind Spot Sensor in accordance with the Service Information. Refer to SENSOR, BLIND SPOT, REMOVAL .
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
No
- Refer to NO RESPONSE FROM PDM (DMRF) (PASSENGER DOOR MODULE) and perform the No Response from Passenger Door Module (PDM) diagnostic procedure.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
- With the scan tool, verify that the Passenger Door Module (PDM) is active on the bus.