D-Clutch Measurement

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Measuring Gap Between D-Clutch Backing Plate & D-Clutch Retainer

Courtesy of CHRYSLER GROUP, LLC

Using (special tool #8901A, Pressing Tool) (3) and (special tool #10429, Gauge, Force) (1) place the D-clutch in a suitable arbor press.
Apply 200 N (45 lbs.) of force to the D-clutch backing plate to compress the wave plate.
With a suitable feeler gauge (2), measure the gap between the C-clutch backing plate and the C-clutch retainer.
Refer to CLUTCH SPECIFICATIONS for specs. If clearance is not within specification a thinner or thicker selectable snap ring can be Installed to achieve proper clearance.