Switch, Remote Radio: Installation: Installation
WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.
NOTE:
With paddle shift shown, without paddle shift similar.
- Route the wire harness through the slot (2) in the steering wheel and connect the wire harness connector (1).
- Position the steering wheel bezel onto the steering wheel.
- Connect the speed control switch electrical connector (3).
- Connect the Electronic Vehicle Information Center (EVIC) switch electrical connector (1).
- Install the two steering wheel bezel retaining screws (2) and securely tighten.
- From the back of the steering wheel, install the two retaining screws (2) that secure the steering wheel bezel (1) and securely tighten.
- Install the left and right steering wheel bezel retaining screw (2).
- Install the left and right switch (1) into the steering wheel opening (3).
- Install the left and right switch (1) retaining screw (2) and securely tighten.
- Install the left and right remote radio switch with paddle shift unit cover (1).
- Install the driver air bag. Refer to AIR BAG, DRIVER, INSTALLATION .
- Connect the negative battery cable.