Outer Tie Rod End

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Tie Rod Ends & Jam Nut

Courtesy of CHRYSLER GROUP, LLC

NOTE:

Do not twist the boot anytime during removal or installation.

Loosen the jam nut (4).
Remove the outer tie rod end nut (1) from the ball stud of the outer tie rod (3).

Fig 2: Outer Tie Rod End, Steering Knuckle & Tie Rod Puller
Courtesy of CHRYSLER GROUP, LLC
Separate the outer tie rod end (4) from the steering knuckle (2) using Tie Rod Puller (special tool #C-3894-A, Puller, Tie Rod) (1).
NOTE:
Count the number of turns when removing the tie rod end as a reference point for installation.
Remove the outer tie rod end (4) from the inner tie rod.