Outer Tie Rod End
WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Do not twist the boot at anytime during removal or installation.
NOTE:
Make sure jam nut (4) is installed on inner tie rod end (4) before the outer tie rod end (2) is installed.
- Thread the outer tie rod end (3) onto the inner tie rod, to it's original position.
- Install the outer tie rod end (3) into the steering knuckle, install the nut and tighten to 95 N.m (70 ft. lbs.).
- Set wheel toe pattern. Refer to WHEEL ALIGNMENT, STANDARD PROCEDURE .
- Tighten the jam nut (4) to 75 N.m (55 ft. lbs.).