Standard Procedure - Fluid Drain And Fill
WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.
- Drive the vehicle until the differential lubricant is at the normal operating temperature.
- With vehicle in neutral, position and raise vehicle on hoist.
- Remove axle drain plug (2) and drain lubricant completely from the axle.
- Install drain plug and tighten to 35 N.m (26 ft lbs).
- Remove fill plug (1) and fill rear axle to the bottom of the fill hole. Refer to CAPACITIES AND RECOMMENDED FLUIDS, SPECIFICATIONS .
- Install fill plug and tighten to 35 N.m (26 ft lbs).