Exhaust Manifold - Right Side

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Oil Fill Cap & Engine Cover

Courtesy of CHRYSLER GROUP, LLC

Remove the oil fill cap (1).
Remove the engine cover (2).

Fig 2: Negative Battery Cable
Courtesy of CHRYSLER GROUP, LLC
Disconnect and isolate the negative battery cable (2).

Fig 3: Right Upstream O2 Sensor & Electrical Connector
Courtesy of CHRYSLER GROUP, LLC

CAUTION:
When servicing or replacing exhaust system components, disconnect the oxygen sensor connector(s). Allowing the exhaust to hang by the oxygen sensor wires will damage the harness and/or sensor.
Disconnect the right upstream 02 sensor electrical connector (1).
Remove the exhaust manifold heat shield front retaining nuts.

Fig 4: Skid Plate & Retaining Bolts
Courtesy of CHRYSLER GROUP, LLC
Raise and support the vehicle.
If equipped, remove the skid plate (1) four retaining bolts (2) and remove the skid plate.
Disconnect the right exhaust pipe/catalytic converter. Refer to CONVERTER, CATALYTIC, REMOVAL .
Remove the exhaust manifold heat shield rear retaining nuts and remove the heat shield.

Fig 5: Removing/Installing Bolts/Studs From Exhaust Manifold In Sequence
Courtesy of CHRYSLER GROUP, LLC

NOTE:
The bolts used to secure the exhaust manifold are stainless steel at locations 7 and 9. All bolts removed must be installed in the same location were they were removed from.
Using the sequence shown in illustration, remove the exhaust manifold retaining bolts.
NOTE:
The right exhaust manifold is removed from below the engine and out through the rear of the engine compartment.
Remove the right exhaust manifold and gasket from below the engine and out through the rear of the engine compartment.
Inspect the exhaust manifold for any damage. Refer to MANIFOLD, EXHAUST, INSPECTION, 5.7L .
Clean the mating surfaces.