Sensor, Camshaft Position: Removal: 5.7L

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Camshaft Position Sensor, Connector, Bolt & Timing Cover

Courtesy of CHRYSLER GROUP, LLC

The Camshaft Position Sensor (CMP) (1) is located on the right side of the timing cover (2) near the engine thermostat housing.

Disconnect the air cleaner and resonator assembly. Refer to BODY, AIR CLEANER, REMOVAL, 5.7L .
Disconnect the electrical connector (4) at the CMP sensor (1).

Fig 2: CMP Sensor & Retaining Bolt
Courtesy of CHRYSLER GROUP, LLC
Remove the CMP sensor retaining bolt (3).
Using a slight rocking motion, carefully remove the CMP sensor (2) from the timing cover (1).
Check the condition of CMP sensor O-ring, replace as necessary.