Coil, Ignition: Removal: 3.6L

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Air Inlet Hose, Intake Air Temperature (IAT) Sensor Connector & Clamps

Courtesy of CHRYSLER GROUP, LLC

Disconnect and isolate the negative battery cable.
If removing the ignition coils from cylinders 1 and 3 on the RH side of the engine, first remove the air inlet hose (3). Refer to MANIFOLD, INTAKE, REMOVAL .

Fig 2: Upper Intake Manifold & Bolts
Courtesy of CHRYSLER GROUP, LLC
If removing the ignition coils from cylinders 2, 4 or 6 on the LH side of the engine, first remove the air inlet hose, upper intake manifold (2) and insulator. Refer to MANIFOLD, INTAKE, REMOVAL .

Fig 3: Electrical Connector, Ignition Coils & Ignition Coil Retaining Bolts
Courtesy of CHRYSLER GROUP, LLC

NOTE:
The LH ignition coils are shown, the RH ignition coils are similar.
Unlock and disconnect the electrical connector (1) from the ignition coil.
Remove the ignition coil mounting bolt (3).
Pull the ignition coil (2) from cylinder head cover opening with a slight twisting action.