Coil, Ignition: Installation: 5.7L

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Ignition Coil

Courtesy of CHRYSLER GROUP, LLC

Using compressed air, blow out any dirt or contaminants from around the top of the spark plug.
NOTE:
Use dielectric grease on each of the spark plug boots before installing the coil.
Position the ignition coil(s) (1) into the valve cover and push onto the spark plug(s).

Fig 2: Identifying 5.7L Ignition Coil
Courtesy of CHRYSLER GROUP, LLC
Install the ignition coil retaining bolts (2) and tighten to 7 N.m (62 in. lbs.).
Connect the electrical connector (1) to the ignition coil(s).