Valve, Coolant Control: Removal: Removal

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect and isolate the negative battery cable.
Drain the coolant system. Refer to STANDARD PROCEDURE .
Remove the cowl extension silencer. Refer to SILENCER, COWL EXTENSION, REMOVAL .

Fig 1: Wire Harness Connector & Coolant Lines
Courtesy of CHRYSLER GROUP, LLC
Disconnect the coolant control valve wire harness connector (1).
Remove the coolant lines (2) from the coolant control valve.

Fig 2: Coolant Control Valve Bracket Bolt, Ignition Capacitor & Bracket
Courtesy of CHRYSLER GROUP, LLC
Remove the coolant control valve bracket bolt (3) located near the right side ignition capacitor (1). Remove the coolant control valve and bracket assembly (2) from the vehicle.