LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2015 >> Durango SXT, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 147 (8HP45/845RE Automatic Transmission (Service Information)) >> Seal, Output Shaft >> Removal >> Rear Wheel Drive

Rear Wheel Drive

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Propeller Shaft Flange, Rear Dust Seal & Rear Oil Seal
GC0152116Courtesy of CHRYSLER GROUP, LLC
NOTE:

Mark the propeller to transmission output flange for assembly reference.

  1. Remove the propeller shaft from the transmission output flange. Move propeller shaft to the right and tie up.
  2. Using a suitable punch, remove the staking from the nut.
  3. Remove the propeller shaft flange nut about using a 34 mm 12 point socket (3) and (special tool #C-3281, Holder, Flange) (2) to hold the flange (1).
  4. Remove the flange (1), and flange dust seal (2).
  5. Remove the output shaft seal (3) with suitable screw and slide hammer.
scientia non olet · About LEMON Manuals