LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2015 >> Durango SXT, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 147 (8HP45/845RE Automatic Transmission (Service Information)) >> Seal, Output Shaft >> Installation >> Rear Wheel Drive

Rear Wheel Drive

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:

The seal must be installed flush with the case. Driving the seal deeper could damage the seal causing a leak.

  1. Position the new output shaft seal over the output shaft and against the transmission case.
  2. Using (special tool #8481, Installer, Gear) install the output shaft seal.
  3. Verify that the transmission is in PARK in order to prepare for the installation of the output shaft nut.
  4. Install the propeller shaft flange onto the output shaft and install an NEW  flange nut. Tighten the nut, with a 34 mm 12 point socket, to 60 N.m (44 ft.lbs.).
  5. Stake the nut.
  6. Install the propeller shaft.
  7. Perform the CHECK OIL LEVEL procedure. Refer to FLUID AND FILTER, STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals