Clutch E Disassembly

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Wave, Friction, Backing & Steel Plates

Courtesy of CHRYSLER GROUP, LLC

1. Wave plate

2. Friction plate

3. Backing plate

4. Steel plate

Fig 2: E-Clutch & Pressing Tool

Courtesy of CHRYSLER GROUP, LLC

Place E-clutch (2) in a suitable press.
Using Pressing Tool 8901A (special tool #8901A, Pressing Tool) (1) compress the E-clutch piston enough to remove the snap ring (3).

Fig 3: Cross Bar Tool
Courtesy of CHRYSLER GROUP, LLC

Fig 4: E-Clutch Piston Support
Courtesy of CHRYSLER GROUP, LLC
Remove the E-clutch piston support (1).

Fig 5: E-Clutch Piston Support
Courtesy of CHRYSLER GROUP, LLC
Remove the E-clutch piston (1).

Fig 6: E-Clutch Wave Washer
Courtesy of CHRYSLER GROUP, LLC

NOTE:
Pay attention to the orientation of the plates.
Remove the wave washer (1), frictions and steels.

Fig 7: E-Clutch Thrust Plate
Courtesy of CHRYSLER GROUP, LLC
Remove the thrust plate (1) last.

Fig 8: Belleville Spring & E-Clutch Hub
Courtesy of CHRYSLER GROUP, LLC
Remove the belleville spring (2) from the E-clutch hub (1).

Fig 9: E-Clutch, Seal & O-Ring
Courtesy of CHRYSLER GROUP, LLC
Remove the E-clutch (1) seal (2) and O-ring (3).