Clutch E Assembly

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Wave, Friction, Backing & Steel Plates

Courtesy of CHRYSLER GROUP, LLC

1. Wave plate

2. Friction plate

3. Backing plate

4. Steel plate

NOTE:

If clutch discs are being replaced, soak in 8HP trans fluid before assembly.

Install the E-clutch (1) seal (2) and O-ring (3).

Fig 2: Belleville Spring & E-Clutch Hub
Courtesy of CHRYSLER GROUP, LLC
Install the belleville (2) spring into the E-clutch hub (1).

Fig 3: E-Clutch Thrust Plate
Courtesy of CHRYSLER GROUP, LLC
Install the clutch pack thrust plate (1).

Fig 4: E-Clutch Wave Washer
Courtesy of CHRYSLER GROUP, LLC
Install the clutch pack frictions and steels (1).

Fig 5: E-Clutch Wave Washer
Courtesy of CHRYSLER GROUP, LLC
Install the wave washer (1) last.

Fig 6: E-Clutch Piston Support
Courtesy of CHRYSLER GROUP, LLC
Install the E-clutch piston (1) onto the hub.

Fig 7: E-Clutch Piston Support
Courtesy of CHRYSLER GROUP, LLC
Install the E-clutch piston support (1).

Fig 8: E-Clutch & Pressing Tool
Courtesy of CHRYSLER GROUP, LLC
Place the E-clutch in a suitable arbor press.
Using Pressing Tool 8901A (special tool #8901A, Pressing Tool) compress the E-clutch enough to install the snap ring.

Fig 9: E-Clutch, Seal & O-Ring

Courtesy of CHRYSLER GROUP, LLC