Clutch B Disassembly

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Wave, Steel, Backing & Friction Plates

Courtesy of CHRYSLER GROUP, LLC

1. Wave plate

2. Steel plate

3. Backing plate

4. Friction plate

Fig 2: P4 Annulus Drum Assembly, Press Fixture Assembly & Bearing/Gear Splitter

Courtesy of CHRYSLER GROUP, LLC

Position the input/output shaft and the P4 annulus drum assembly (1) on Assembly, Press Fixture 8925-3 (special tool #8925-3, Assembly, Press Fixture) and Splitter, Bearing/Gear 1130 (special tool #1130, Splitter, Bearing/Gear).

Fig 3: Press Fixture
Courtesy of CHRYSLER GROUP, LLC

Fig 4: Splitter, Bearing/Gear
Courtesy of CHRYSLER GROUP, LLC

Fig 5: Annulus Assembly & Shim
Courtesy of CHRYSLER GROUP, LLC
Remove the selectable shim (1).

Fig 6: Annulus Assembly & Gear
Courtesy of CHRYSLER GROUP, LLC
Remove the P1 (1) annulus from the assembly.

Fig 7: Annulus Assembly & B-Clutch Wave Plate
Courtesy of CHRYSLER GROUP, LLC
Remove the B-clutch wave plate (1).

Fig 8: Friction & Steel Plates
Courtesy of CHRYSLER GROUP, LLC
Remove the friction and steel plates (2).

Fig 9: Backing Plate & Annulus Assembly
Courtesy of CHRYSLER GROUP, LLC
Remove the backing plate (1) from the assembly (2).