When Monitored

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.

This diagnostic runs continuously when the following conditions are met:

Shifter is in the DRIVE position.
Transmission oil temperature is above a calibrated value.
No clutch slip control functions commanded.
No Input Speed Sensor signal Diagnostic Trouble Codes (DTCs) set.
Input Speed Sensor signal is above a calibrated value.
Output Speed Sensor signal is valid or the output speed can be calculated from the wheel speed Controller Area Network (CAN) signal if the Output Speed Sensor signal is not available.
Engine speed signal via CAN or Output Speed Sensor signal is above a calibrated value.
When a gear shift is in progress:
- The output speed and the output speed gradient must be higher than a calibrated value.
When a gear is engaged:
- The absolute value of the input speed gradient and pedal position must be lower than their respective calibrated values.