Theory Of Operation
WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.
The Electronic Throttle Control (ETC) system uses two Throttle Position Sensors (TPS) to monitor the throttle blade position. TPS 1 and TPS 2 are located within the Throttle Body assembly. Each sensor has its own Signal circuit (TPS 1 or TPS 2). Both sensors share a 5-volt reference circuit (Supply) and a low reference circuit (Sensor Return). Processors within the Powertrain Control Module (PCM) monitor the ETC system data. Each Signal circuit provides the processors with a signal voltage proportional to throttle blade movement. The processors share and monitor data to verify that the indicated TPS calculation is correct.