Diagnosis And Testing - Propeller Shaft: Balance

Fig 1: Screw Clamp & Propeller Shaft

Courtesy of CHRYSLER GROUP, LLC

If propeller shaft is suspected of being unbalanced, it can be verified with the following procedure:

1. Raise the vehicle.
2. Clean all the foreign material from the propeller shaft and the universal joints.
3. Inspect the propeller shaft for missing balance weights, broken welds, and bent areas.
4. Inspect the universal joints to ensure that they are not worn, are properly installed, and are correctly aligned with the shaft.
5. Check the universal joint flange screws torque.
6. Remove the wheels and tires. Install the wheel lug nuts to retain the brake drums or rotors.
7. Mark and number the shaft six inches from the yoke end at four positions 90° or 45° apart depending on flange.
8. Run and accelerate the vehicle until vibration occurs. Note the intensity and speed the vibration occurred. Stop the engine.
9. Install a screw clamp (1) at position 1.
   Fig 2: Separating Clamps

   Courtesy of CHRYSLER GROUP, LLC
10. Start the engine and re-check for vibration. If there is little or no change in vibration, move the clamp to one of the other three positions. Repeat the vibration test.
11. If there is no difference in vibration at the other positions, the source of the vibration may not be propeller shaft.
12. If the vibration decreased, install a second clamp (1) on the shaft (2) and repeat the test.
    Fig 3: Staggering Clamps

    Courtesy of CHRYSLER GROUP, LLC
13. If the additional clamp causes an additional vibration, separate the first clamp (1) and second clamp (2) (1/4 inch above and below the mark). Repeat the vibration test.
14. Increase distance between the clamp screws and repeat the test until the amount of vibration is at the lowest level. Bend the slack end of the clamps so the screws will not loosen.
15. If the vibration remains unacceptable, apply the same steps to the front end of the propeller shaft.
16. Install the wheel and tires. Lower the vehicle.