LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2015 >> Durango SXT, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 139 (Base Brakes (Service Information)) >> Parking Brake >> Lever, Parking Brake >> Installation >> Installation

Lever, Parking Brake: Installation: Installation

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Bolts & Clip
GC0145670Courtesy of CHRYSLER GROUP, LLC
  1. Position the parking brake lever assembly, install the retainer bolts/nuts (1) and tighten to 24 N.m (18 ft. lb.).
  2. Connect the wiring harness connector to the parking brake switch (2).
  3. Attach the instrument panel wiring harness connector to the parking brake assembly harness retainer clip (3).
    Fig 2: Cable, Bracket Assembly & Cable End
    GC0145684Courtesy of CHRYSLER GROUP, LLC
  4. Install the front cable end (1) into the brake lever assembly (3).
    Fig 3: Cable Housing Tabs, Cable Housing & Bracket Assembly
    GC0145685Courtesy of CHRYSLER GROUP, LLC
  5. Install the front cable housing (3) to the bracket (1).
  6. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
    Fig 4: Rear Parking Brake Cables, Equalizer & Body Retaining Nut
    GC0145671Courtesy of CHRYSLER GROUP, LLC
  7. Connect the right rear and left rear parking cables (2, 5) to the equalizer (1).
  8. Remove the supports and lower the vehicle.
  9. Remove the lockout of the parking brake assembly. Refer to PARKING BRAKE, STANDARD PROCEDURE .
  10. Install the side cowl trim panel. Refer to PANEL, COWL TRIM, SIDE, INSTALLATION .
scientia non olet · About LEMON Manuals