Cable, Parking Brake: Removal: Front
WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
- Disconnect the right rear and left rear parking brake cables (2, 5) from the equalizer (1).
- Remove the cable to body retaining nut (3) and clip from the stud.
- Remove the supports and lower the vehicle.
- Remove the steering column opening cover. Refer to COVER, STEERING COLUMN OPENING, REMOVAL .
- Remove the left footwell load floor. Refer to LOAD FLOOR, FOOTWELL, REMOVAL .
- Remove the left rear seat. Refer to SEAT, SECOND ROW, REMOVAL or SEAT, THIRD ROW, REMOVAL .
- Lockout the parking brake lever assembly. Refer to PARKING BRAKE, STANDARD PROCEDURE .
- Depress the cable housing tabs (3) and remove the cable housing (2) from the bracket assembly (1).
- Pull the cable (2) up to align with the slot in the bracket assembly (3) and remove the cable end (1) from the bracket assembly (3).
- Remove the wiring harness from the body retaining studs (2) as necessary.
- Remove the front parking brake cable to body retaining nuts (2) and clips from the studs.
- Disengage the grommet, pull the cable through the floor and remove the cable from the vehicle.