LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2015 >> Durango SXT, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 139 (Base Brakes (Service Information)) >> Hydraulic/Mechanical >> Tubes And Hoses, Brake >> Installation >> Primary And Secondary Brake Tubes

Primary And Secondary Brake Tubes

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Hydraulic Control Unit (HCU), Primary & Secondary Brake Tubes, Chassis Lines & Antilock Brake System (ABS) Module Electrical Connector
GC0145596Courtesy of CHRYSLER GROUP, LLC
  1. Position the primary or secondary brake tube(s) (2) in the vehicle and attach to the routing clip.
  2. Connect the primary or secondary brake tube(s) (2) at the HCU (1) and tighten to 19 N.m (168 in. lbs.).
    Fig 2: Brake Lines, Master Cylinder & Nuts
    GC0145591Courtesy of CHRYSLER GROUP, LLC
  3. Connect the primary or secondary brake tube(s) (4) at the master cylinder (1) and tighten to 19 N.m (168 in. lbs.).
    Fig 3: Power Steering Reservoir, Hoses & Retaining Screw
    GC0145584Courtesy of CHRYSLER GROUP, LLC
  4. If removed, route the power steering hoses and reservoir, install the routing clips, install the retaining bolt and tighten to 20 N.m (15 ft. lbs.).
    Fig 4: Connector, Hood Weather Strip, Extension, Fastener & Tab
    GC0145592Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    Make sure the tab (4) is snaps into place.

  5. Position the cowl side extension (5) and install the cowl side extension to cowl extension fastener (1).
  6. Install the hood weather strip (2) into position and attach the connector (3) to the body.
  7. Install the air cleaner body. For 3.6L, refer to AIR CLEANER, INSTALLATION . For 5.7L, refer to AIR CLEANER, INSTALLATION .
  8. Remove the prop rod from the brake pedal.
  9. Fill and pressure bleed the brake system. Refer to STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals