Flexible Hose

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Front flexible brake hose shown, rear similar.

Fig 1: Solid Brake Line Fitting, Flexible Brake Hose & Retaining Clip

Courtesy of CHRYSLER GROUP, LLC

Position the flexible brake hose (2) through the bracket and install the retaining clip (3).
Tighten the solid brake line fitting (1) to 19 N.m (168 in. lbs.).

Fig 2: Wiring Routing Clip, Flexible Brake Hose, Banjo Bolt & Brake Hose
Courtesy of CHRYSLER GROUP, LLC
Install new washers , and the banjo bolt through the line and into the caliper. Tighten the banjo bolt to 30 N.m (22 ft. lbs.).
If equipped, connect the wheel speed sensor wiring routing clip (1) to the flexible brake hose (2).
If installing the rear flexible brake hose, install the tire and wheel assembly. Refer to WHEELS, STANDARD PROCEDURE .
Remove the supports and lower the vehicle.
Remove the prop rod from the brake pedal.
Bleed the area of repair for the brake system. If a proper pedal is not felt during bleeding an area of repair then a base bleed system must be performed . Refer to STANDARD PROCEDURE .