Torque Specifications
WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| DESCRIPTION | N.m | Ft. Lbs. | In. Lbs. | COMMENT |
|---|---|---|---|---|
| Active Damping System (ADS) Sensor Retainer (with SMC) | 9 | - | 80 | |
| Air Line Fitting to Spring And Shock Assembly (With SER) | 5.5 | - | 49 | |
| Shock Absorber Upper Nuts | 28 | 21 | - | Do not reuse fastener. If removed, a new fastener must be installed and tightened to specifications. |
| Shock Upper Mounting Nut | 50 | 37 | - | Do not reuse fastener. If removed, a new fastener must be installed and tightened to specifications. |
| Clevis Bracket to Lower Control Arm | 255 | 188 | - | Do not reuse fastener. If removed, a new fastener must be installed and tightened to specifications. |
| Upper Control Arm Bolt/Nut to Body | 95 | 70 | - | Do not reuse fastener. If removed, a new fastener must be installed and tightened to specifications. |
| Lower Control Arm Rear Pivot Vertical Bolt/Nut | 173 | 128 | - | Do not reuse fastener. If removed, a new fastener must be installed and tightened to specifications. |
| Lower Control Arm Rear Pivot Horizontal Bolt/Nut | 173 | 128 | - | Do not reuse fastener. If removed, a new fastener must be installed and tightened to specifications. |
| Lower Control Arm Front Pivot Bolt/Nut | 130 | 96 | - | Do not reuse fastener. If removed, a new fastener must be installed and tightened to specifications. |
| Upper Ball Joint Nut | 165 | 122 | - | Do not reuse fastener. If removed, a new fastener must be installed and tightened to specifications. |
| Lower Ball Joint Nut | 125 | 92 | - | Do not reuse fastener. If removed, a new fastener must be installed and tightened to specifications. |
| Stabilizer Bar Retainer Bolts | 115 | 85 | - | Do not reuse fastener. If removed, a new fastener must be installed and tightened to specifications. |
| Stabilizer Bar Link Upper Nut | 85 | 63 | - | Do not reuse fastener. If removed, a new fastener must be installed and tightened to specifications. |
| Stabilizer Bar Link Lower Bolt | 130 | 96 | - | Do not reuse fastener. If removed, a new fastener must be installed and tightened to specifications. |
| Tie Rod End Ball Stud Nut | 95 | 70 | - | |
| Half Shaft Nut | 310 | 229 | - | |
| Intermediate Shaft Pinch Bolt | 45 | 33 | - | |
| Hub Bearing Knuckle Bolts | 100 | 74 | - | |
| Brake Caliper Slide Bolts (Guide Pins) | 55 | 41 | - | |
| Brake Caliper Adapter Bolts | 170 | 125 | - | |
| Speed Sensor Bolts | 6.8 | 5 | 60 |