LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2015 >> Durango SXT, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 137 (Front Suspension & Wheel Alignment) >> Front >> Hub And Bearing >> Installation >> 4X4

Hub And Bearing: Installation: 4X4

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Hub/Bearing & Bolts
GC0173639Courtesy of CHRYSLER GROUP, LLC
  1. Position the hub/bearing, install the hub/bearing bolts (2) and tighten to 105 N.m (78 ft. lbs.).
  2. Install a NEW  half shaft nut and tighten to 310 N.m (229 ft. lbs.).
  3. Install the brake rotor. Refer to ROTOR, BRAKE, INSTALLATION .
    Fig 2: Front Suspension Nuts & Bolts
    GC0173647Courtesy of CHRYSLER GROUP, LLC
  4. Route and attach speed sensor wiring to the knuckle.
  5. Install the wheel speed sensor into the knuckle, install the mounting bolt (2) and tighten to 10.7 N.m (95 in. lbs.).
  6. Install the stabilizer link (7) and tighten to 122 N.m (90 ft. lbs.).
  7. Install the tire and wheel assembly. Refer to WHEELS, STANDARD PROCEDURE .
  8. Remove the supports and lower the vehicle.
scientia non olet · About LEMON Manuals