Diagnostic Test
WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.
- VERIFY THE DTC IS ACTIVE NOTE:
This DTC must be active for the results of this test to be valid.
- Turn the ignition on.
- With the scan tool, read and record DTCs.
- With the scan tool, read and record Freeze Frame information.NOTE:
Make sure the wheels are pointing straight and the vehicle is on level ground before proceeding.
With the scan tool, under "Miscellaneous Functions" perform the ABS Initialization routine. Perform the ABS VERIFICATION TEST. Refer to ABS VERIFICATION TEST .
- With the scan tool, read and record DTCs.
Is the DTC active at this time?
Yes
- Go To 2
No
- Test complete, the condition or conditions that originally set this DTC are not present at this time.
- CHECK THE DYNAMICS SENSOR INSTALLATION NOTE:
Dynamics Sensor installation and mounting bolt torque is crucial for proper operation.
- Turn the ignition off.
- Check the Dynamics Sensor for damaged, modified, proper orientation and bent mounting brackets.
- Check the Dynamics Sensor mounting bolts for a loose or over tightened condition.
Were any problems found?
Yes
- Repair as necessary.
- Perform the ABS VERIFICATION TEST. Refer to ABS VERIFICATION TEST .
No
- Go To 3
- DYNAMICS SENSOR
- Replace the Dynamics Sensor in accordance with the Service Information. Perform the ABS VERIFICATION TEST. Refer to ABS VERIFICATION TEST
.WARNING:
Make sure brake capability is available before road testing.
- Park the vehicle.
- With the scan tool, read ABS DTCs.
Does the DTC remain active?
Yes
- Replace the Anti-lock Brake System (ABS) Module in accordance with the Service Information. Refer to MODULE, ANTI-LOCK BRAKE SYSTEM, REMOVAL .
- Perform the ABS VERIFICATION TEST. Refer to ABS VERIFICATION TEST .
No
- Test complete.
- Replace the Dynamics Sensor in accordance with the Service Information. Perform the ABS VERIFICATION TEST. Refer to ABS VERIFICATION TEST
.