Diagnostic Test
WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK FOR AN ACTIVE DTC NOTE:
If DTC C003A-1D is present, perform the diagnostics for this DTC before continuing with this diagnostic procedure.
NOTE:This vehicle uses directional front wheel speed sensors and non-directional rear wheel speed sensors.
- Turn the ignition on.
- With the scan tool, record and erase DTCs.
- With the scan tool, read DTCs.
Is the DTC active?
Yes
- Go To 2
No
- Test Complete.
- RIGHT REAR WHEEL SPEED SENSOR NOTE:
This vehicle uses a non-directional rear wheel speed sensor, make sure the correct wheel speed sensor is installed on the vehicle.
- Replace the Right Rear Wheel Speed Sensor in accordance with the Service Information. Refer to SENSOR, WHEEL SPEED, FRONT, REMOVAL
. Perform the ABS VERIFICATION TEST. Refer to ABS VERIFICATION TEST
.CAUTION:
Make sure braking capability is available before road testing.
- Road test the vehicle over 40 km/h (25 mph).
- With the scan tool, read DTCs.
Does the DTC remain active?
Yes
- Replace the Anti-lock Brake System (ABS) Module in accordance with the Service Information. Refer to MODULE, ANTI-LOCK BRAKE SYSTEM, REMOVAL .
- Perform the ABS VERIFICATION TEST. Refer to ABS VERIFICATION TEST .
No
- Test complete.
- Replace the Right Rear Wheel Speed Sensor in accordance with the Service Information. Refer to SENSOR, WHEEL SPEED, FRONT, REMOVAL
. Perform the ABS VERIFICATION TEST. Refer to ABS VERIFICATION TEST
.