A/C Clutch
WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The A/C clutch can be serviced with the refrigerant system fully charged.
NOTE:
Typical A/C compressor and clutch assembly shown in illustrations.
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Remove the accessory drive belt. Refer to BELT, SERPENTINE, REMOVAL .
- Disconnect the engine wire harness from the A/C clutch coil connector (1).
- If required (depending on A/C compressor application), remove the A/C clutch coil connector and lead from the connector bracket (2).
- If required, remove the A/C compressor from the engine and support the compressor. Refer to COMPRESSOR, A/C, REMOVAL .
- Remove the compressor shaft bolt (3). A band-type oil filter wrench or a strap wrench may be used to hold the clutch plate (4) from rotating during bolt removal.
CAUTION:
Do not pry between the clutch plate and the pulley and bearing assembly to remove the clutch plate from the compressor shaft as this may damage the clutch plate.
NOTE:Use care not to lose any clutch shim(s) during removal of the clutch plate, as they may be reused during the clutch plate installation process.
- Tap the clutch plate (2) lightly with a plastic mallet to release it from the splines on the compressor shaft (1) and remove the clutch plate and shim(s) (3).
- Using A/C Snap Ring Pliers (special tool #9764, Pliers, A/C Snap Ring) (1) or equivalent, remove the snap ring (2) that secures the pulley and bearing assembly (3) to the A/C compressor and remove the pulley and bearing assembly.
- Using A/C Snap Ring Pliers (special tool #9764, Pliers, A/C Snap Ring) (1) or equivalent, remove the snap ring (4) that secures the A/C clutch coil (2) to the A/C compressor (3) and remove the coil.