3.6L Engine
WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Review the warnings and cautions for this system before performing the procedure. Failure to follow these instructions may result in serious injury or death.
NOTE:
The A/C condenser must be replaced if an internal failure of the A/C compressor has occurred. Refer to CONDENSER, A/C, REMOVAL .
NOTE:
The A/C compressor may be removed and repositioned without disconnecting the refrigerant lines or discharging the refrigerant system. Discharging is not necessary if servicing the A/C clutch, clutch coil or engine.
NOTE:
LHD model shown in illustrations. RHD model similar.
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Remove the engine cover.
- Recover the refrigerant from the refrigerant system. Refer to PLUMBING, STANDARD PROCEDURE .
- Remove the air cleaner housing. Refer to BODY, AIR CLEANER, REMOVAL .
- Remove the accessory drive belt. Refer to BELT, SERPENTINE, REMOVAL .
- Remove the nuts (1 and 3) that secure the A/C suction line (2) and A/C discharge line (3) to the A/C compressor.
- Disconnect the refrigerant lines from the A/C compressor and remove and discard the seals.
- Install plugs in, or tape over all of the opened refrigerant line fittings and the compressor ports.
- Disconnect the engine wire harness from the A/C compressor (2).
- Remove the nut (5) and position the heater tube and bracket (4) out of the way.
- Support the A/C compressor and remove the stud (3) and the three bolts (1).
- Remove the A/C compressor from the engine compartment.