LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2015 >> Durango SXT, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 133 (Heating & Air Conditioning (Service Information)) >> Distribution >> Housing, HVAC >> Installation >> Housing-Air Inlet

Housing-Air Inlet

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

The air inlet housing must be removed from HVAC housing and disassembled for service of the recirculation-air door.

NOTE:

LHD model shown in illustration. RHD model similar.

Fig 1: One Screw, Air Inlet Housing & HVAC Housing
GC0145922Courtesy of CHRYSLER GROUP, LLC
  1. Position the air inlet housing (2) to the top of the HVAC housing (3) and engage the two tab-and-slot type retainers (4) located on the right side of the housings.
  2. Tip the left side of the air inlet housing downward until it is properly seated on the HVAC housing.
  3. Install the screw (1) that secures the air inlet housing to the HVAC housing. Tighten the screw to 2.2 N.m (20 in. lbs.).
    Fig 2: Door Actuator, Two Screws, Air Inlet Housing & HVAC Housing
    GC0145921Courtesy of CHRYSLER GROUP, LLC
  4. Install the two screws (4) that secure the left side of the air inlet housing (2) to the HVAC housing (3). Tighten the screw to 2.2 N.m (20 in. lbs.).
  5. Connect the wire harness connector to the recirculation door actuator (1).
  6. Install the HVAC housing assembly. Refer to HOUSING, HVAC, INSTALLATION .
scientia non olet · About LEMON Manuals