LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2015 >> Durango SXT, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 133 (Heating & Air Conditioning (Service Information)) >> Controls >> Transducer, A/C Pressure >> Removal >> Removal

Transducer, A/C Pressure: Removal: Removal

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

It is not necessary to discharge the refrigerant system to replace the A/C pressure transducer.

Fig 1: Removing/Installing A/C Pressure Transducer
GC0082715Courtesy of CHRYSLER GROUP, LLC
NOTE:

Typical A/C pressure transducer and refrigerant line shown.

  1. Disconnect and isolate the negative battery cable.
  2. Disconnect the wire harness connector (1) from the A/C pressure transducer (2) located on the A/C discharge line (3).
  3. Remove the A/C pressure transducer from the fitting on the A/C discharge line and remove and discard the O-ring seal.
scientia non olet · About LEMON Manuals