Manifold, Intake: Removal: Lower

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.

Release the fuel system pressure. Refer to FUEL DELIVERY, GAS, STANDARD PROCEDURE .
Remove the upper intake manifold. Refer to MANIFOLD, INTAKE, REMOVAL .

Fig 1: Insulator
Courtesy of CHRYSLER GROUP, LLC
Remove the insulator (1) from the right cylinder head cover.

Fig 2: Fuel Supply Hose
Courtesy of CHRYSLER GROUP, LLC
Disconnect the fuel supply hose (1) from the fuel rail inlet. Refer to FITTING, QUICK CONNECT, STANDARD PROCEDURE .

Fig 3: Fuel Injector Wire Harness Connectors & Wire Harness
Courtesy of CHRYSLER GROUP, LLC
Disconnect the fuel injector wire harness connectors (1) and position the wire harness (2) aside.

Fig 4: Fuel Rail Bolts
Courtesy of CHRYSLER GROUP, LLC
Remove the bolts (1), then lift the fuel rail and fuel injectors from the lower intake manifold.

Fig 5: Lower Intake Manifold Bolt Removal & Tightening Sequence
Courtesy of CHRYSLER GROUP, LLC
Using the sequence shown in illustration, remove the bolts and lower intake manifold.

Fig 6: Lower Intake Manifold To Cylinder Head Gaskets
Courtesy of CHRYSLER GROUP, LLC
Inspect and reuse the six lower intake manifold to cylinder head gaskets if no issue are found.