Manifold, Intake: Installation: Lower

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Lower Intake Manifold To Cylinder Head Gaskets

Courtesy of CHRYSLER GROUP, LLC

Clean and inspect the sealing surfaces, the gaskets may be reused if no issues are found. Install the lower intake manifold to cylinder head gaskets.

Fig 2: Lower Intake Manifold Bolt Removal & Tightening Sequence
Courtesy of CHRYSLER GROUP, LLC
Position the lower intake manifold on the cylinder head surfaces.
Tighten the bolts to the proper in the sequence shown in illustration. Refer to TORQUE SPECIFICATIONS .

Fig 3: Fuel Rail Bolts
Courtesy of CHRYSLER GROUP, LLC
Install the fuel injectors and the fuel rail to the lower intake manifold. Tighten the bolts (1) to the proper specification. Refer to FUEL DELIVERY, GAS, SPECIFICATIONS .

Fig 4: Fuel Injector Wire Harness Connectors & Wire Harness
Courtesy of CHRYSLER GROUP, LLC
Position the wire harness (2) and connect the fuel injector wire harness connectors (1).

Fig 5: Fuel Supply Hose
Courtesy of CHRYSLER GROUP, LLC
Connect the fuel supply hose (1) to the fuel rail. Refer to FITTING, QUICK CONNECT, STANDARD PROCEDURE .

Fig 6: Insulator
Courtesy of CHRYSLER GROUP, LLC
Install the insulator (1) on top of the right cylinder head cover.
Install the upper intake manifold. Refer to MANIFOLD, INTAKE, INSTALLATION .
Start the engine and check for leaks.