LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2015 >> Durango SXT, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 132 (3.6L Engine (Service Information)) >> Lubrication >> Diagnosis And Testing >> Checking Engine Oil Pressure

Checking Engine Oil Pressure

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the oil filter and cap. Refer to FILTER, ENGINE OIL, REMOVAL .
  2. Transfer the oil filter to the (special tool #2021500090, Adapter, Late Version 3.6L Oil Pressure Test).
  3. Install Pressure Gauge (special tool #C-3292A, Gauge, Pressure) (1) to the Oil Pressure Test Adapter.
  4. Install the Oil Pressure Test Adapter to the engine and securely tighten.
  5. Start and idle the engine. If oil pressure is 0 at idle, shut off the engine and consult the Engine Lubrication and Diagnostic Table. Refer to ENGINE LUBRICATION DIAGNOSTIC TABLE .
  6. Run the engine until it reaches normal operating temperature.
  7. Verify that the engine has acceptable oil pressure. Refer to ENGINE SPECIFICATIONS .
scientia non olet · About LEMON Manuals