Insulator, Engine Mount, Left: Removal: Removal

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect and isolate the negative battery cable.
Remove the upper intake manifold and insulator. Refer to MANIFOLD, INTAKE, REMOVAL .

Fig 1: Left Engine Mount Heat Shield Bolts
Courtesy of CHRYSLER GROUP, LLC
Remove the bolts (1) and the engine mount heat shield from both the left and right engine mounts.

Fig 2: Left Engine Mount Nut
Courtesy of CHRYSLER GROUP, LLC
Remove both the left and right engine mount nuts (1).

Fig 3: Placing Engine Support Fixture On Right Side Of Inner Body Structure
Courtesy of CHRYSLER GROUP, LLC
Remove the closeout panels and place the engine support fixture as shown in illustration on the right side of the inner body structure (1).

Fig 4: Placing Engine Support Fixture On Left Side Of Inner Body Structure
Courtesy of CHRYSLER GROUP, LLC
Remove the closeout panels and place the engine support fixture as shown in illustration on the left side of the inner body structure (1).

Fig 5: Engine Support Fixture
Courtesy of CHRYSLER GROUP, LLC
Install the Engine Support Fixture (1) (special tool #8534B, Fixture, Driveline Support) and carefully lift the engine only high enough to gain enough clearance to remove the mount.

Fig 6: Left Engine Mount Isolator Bolts
Courtesy of CHRYSLER GROUP, LLC
Remove the two bolts (1) from the left engine mount isolator.
Remove the left engine mount isolator from the vehicle.
If required, remove the four bolts from the left engine mount bracket and remove the bracket from the vehicle.