LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2015 >> Durango SXT, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 132 (3.6L Engine (Service Information)) >> Engine Block >> Seal, Crankshaft Oil, Front >> Removal >> Removal

Seal, Crankshaft Oil, Front: Removal: Removal

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Sleeve & Flywheel Key
GC0144224Courtesy of CHRYSLER GROUP, LLC
  1. Remove the accessory drive belt and the crankshaft vibration damper. Refer to DAMPER, VIBRATION, REMOVAL .
  2. Install the sleeve (2) from Seal Remover (special tool #8511, Remover, Seal) around the flywheel key (1) and onto the nose of the crankshaft.
    Fig 2: Seal Remover & Front Crankshaft Oil Seal
    GC0144225Courtesy of CHRYSLER GROUP, LLC
  3. Screw Seal Remover (special tool #8511, Remover, Seal) (1) into the front crankshaft oil seal (2).
    Fig 3: Extractor Screw, Seal Remover & Front Crankshaft Oil Seal
    GC0144226Courtesy of CHRYSLER GROUP, LLC
  4. Install the extractor screw (2) into the Seal Remover (special tool #8511, Remover, Seal) (1). Hold the seal remover stationary and tighten the extractor screw against the sleeve until the front crankshaft oil seal (3) is removed from the engine timing cover.
scientia non olet · About LEMON Manuals