LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2015 >> Durango SXT, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 132 (3.6L Engine (Service Information)) >> Cylinder Head >> Solenoid, Variable Valve Lift >> Removal >> Bank 2 Solenoid 2

Bank 2 Solenoid 2

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable.
  2. Remove the cowl extension. Refer to SILENCER, COWL EXTENSION, REMOVAL .
    Fig 1: Rear Engine Wire Harness
    GC0173761Courtesy of CHRYSLER GROUP, LLC
  3. Position the rear engine wire harness (1) aside.
    Fig 2: Variable Valve Lift (VVL) Solenoid Wire Harness Connector & Retaining Bolt
    GC0173713Courtesy of CHRYSLER GROUP, LLC
  4. Disconnect the wire harness connector (1) from the Variable Valve Lift (VVL) solenoid.
  5. Remove the VVL solenoid retaining bolt (2).
  6. Remove the VVL solenoid from the cylinder head.
  7. The O-ring seal can be reused if not damaged.
scientia non olet · About LEMON Manuals