LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2015 >> Durango SXT, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 132 (3.6L Engine (Service Information)) >> Cylinder Head >> Solenoid, Variable Valve Lift >> Removal >> Bank 1 Solenoid 2

Bank 1 Solenoid 2

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the upper intake manifold. Refer to MANIFOLD, INTAKE, REMOVAL .
    Fig 1: Variable Valve Lift (VVL) Solenoid Wire Harness Connector & Retaining Bolt
    GC0173650Courtesy of CHRYSLER GROUP, LLC
  2. Disconnect the wire harness connector (1) from the Variable Valve Lift (VVL) solenoid.
  3. Remove the VVL solenoid retaining bolt (2).
  4. Remove the VVL solenoid from the cylinder head.
  5. The O-ring seal can be reused if not damaged.
scientia non olet · About LEMON Manuals