Section 130 (Engine Cooling System): Engine: Thermostat: Installation: 5.7L
WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.
- Position the thermostat on the front cover with the vent at the 12 o'clock position.
- Install the thermostat housing (2). Tighten the bolts (1) to 13 N.m (115 in. lbs.).
- Install the radiator hose onto the thermostat housing.
- Fill the cooling system. Refer to STANDARD PROCEDURE .
- Connect negative battery cable.
- Install the air intake system. Refer to BODY, AIR CLEANER, INSTALLATION, 5.7L .
- Start and warm the engine. Check for leaks. Refer to COOLING SYSTEM LEAKS .