Section 130 (Engine Cooling System): Engine: Thermostat: Installation: 3.6L

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.

Clean the mating surfaces on the timing cover and thermostat housing.

Fig 1: Thermostat Housing Gasket
Courtesy of CHRYSLER GROUP, LLC
Install a NEW thermostat housing gasket (1).

Fig 2: Thermostat Housing Bolts
Courtesy of CHRYSLER GROUP, LLC
Install the thermostat housing and tighten the bolts (1) finger tight.

Fig 3: Thermostat Housing Bolts Tightening Sequence
Courtesy of CHRYSLER GROUP, LLC
Using the tighten sequence shown in illustration tighten the bolts the proper specification. Refer to SPECIFICATIONS .

Fig 4: Coolant Temperature Sensor Connector
Courtesy of CHRYSLER GROUP, LLC
Connect the Engine Coolant Temperature (ECT) sensor (1) wire harness connector.

Fig 5: Upper Radiator Hose
Courtesy of CHRYSLER GROUP, LLC
Install the upper radiator hose (1) onto the thermostat housing.

Fig 6: Coolant Hose From Thermostat Housing
Courtesy of CHRYSLER GROUP, LLC
Install the coolant hose (1) onto the thermostat housing.
Fill the cooling system. Refer to STANDARD PROCEDURE .
Install the air cleaner body. Refer to BODY, AIR CLEANER, INSTALLATION .
Connect the negative battery cable.
Run the engine until it reaches normal operating temperature. Check the cooling system for leaks and correct fluid level. Refer to STANDARD PROCEDURE .