Throttle Body: Removal: 5.7L

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Negative Battery Cable

Courtesy of CHRYSLER GROUP, LLC

Perform the fuel pressure release procedure. Refer to FUEL DELIVERY, GAS, STANDARD PROCEDURE .
Disconnect the negative battery cable (2).

Fig 2: Oil Fill Cap & Engine Cover
Courtesy of CHRYSLER GROUP, LLC
Remove the oil fill cap (1).
Remove the engine cover (2).

Fig 3: Intake Air Temperature (IAT) Sensor, Air Cleaner Housing, Resonator Retaining Bolt & Hose Clamp
Courtesy of CHRYSLER GROUP, LLC
Disconnect the electrical connector at the Intake Air Temperature (IAT) sensor (1).
Loosen the hose clamp at the air cleaner housing (2).
Remove the resonator retaining bolt (3).
Loosen the hose clamp at the throttle body (4) and remove the resonator.

Fig 4: Throttle Body, Throttle Body Mounting Bolts & Electrical Connector
Courtesy of CHRYSLER GROUP, LLC
Disconnect the electrical connector at the throttle body (3).
Remove the four throttle body retaining bolts (2).
Remove the throttle body (1) from the intake manifold.

Fig 5: Intake Manifold & Throttle Body O-Ring
Courtesy of CHRYSLER GROUP, LLC
Check the throttle body O-ring (2), replace if necessary.