Throttle Body: Removal: 3.6L

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Never have the ignition key in the ON position when checking the throttle body shaft for a binding condition. This may set DTC's.

Disconnect and isolate the negative battery cable.
Remove the air cleaner body. Refer to BODY, AIR CLEANER, REMOVAL .

Fig 1: Throttle Body Connector & Clip
Courtesy of CHRYSLER GROUP, LLC
Disconnect the throttle body wire harness connector (1) and disengage the wire harness clip (2) from the throttle body.

Fig 2: Throttle Body Bolts
Courtesy of CHRYSLER GROUP, LLC
Remove the four bolts (1) and the throttle body.

Fig 3: Throttle Body O-Ring
Courtesy of CHRYSLER GROUP, LLC
Remove and discard the O-ring seal (1).