Sensor, Manifold Air Pressure (Map): Removal: 3.6L

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect and isolate the negative battery cable.
Remove the engine cover. Refer to COVER, ENGINE, REMOVAL .

Fig 1: Manifold Air Pressure Sensor Connector
Courtesy of CHRYSLER GROUP, LLC
Disconnect the Manifold Air Pressure (MAP) sensor wire connector (1).

Fig 2: Manifold Air Pressure Sensor
Courtesy of CHRYSLER GROUP, LLC
Rotate the MAP sensor (1) 1/4 turn counterclockwise and pull the sensor straight up and out of the upper intake manifold.

Fig 3: Manifold Air Pressure Sensor & O-Ring
Courtesy of CHRYSLER GROUP, LLC
The MAP sensor O-ring can be reused if not damaged.