Sensor, Crankshaft Position: Removal: 5.7L
WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.
The Crankshaft Position (CKP) sensor (4) is located at the right-rear side of the engine cylinder block (1). It is positioned and bolted into a machined hole in the engine block.
- Raise vehicle.
- Disconnect CKP electrical connector (2) at sensor.
- Remove CKP mounting bolt (3).
- Carefully twist sensor from cylinder block.
- Remove sensor from vehicle.
- Check condition of sensor o-ring.