Sensor, Crankshaft Position: Removal: 3.6L

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.

The Crankshaft Position (CKP) sensor is mounted into the right rear side of the cylinder block.

Disconnect and isolate the negative battery cable.
Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .

Fig 1: Crankshaft Position Sensor Connector
Courtesy of CHRYSLER GROUP, LLC
Disconnect the Crankshaft Position (CKP) Sensor wire harness connector (1).

Fig 2: Crankshaft Position Sensor Bolt
Courtesy of CHRYSLER GROUP, LLC
Remove the CKP sensor bolt (1).

Fig 3: Removing/Installing Crankshaft Position Sensor
Courtesy of CHRYSLER GROUP, LLC
Carefully twist the CKP sensor (1) and remove from the cylinder block.

Fig 4: CKP Sensor O-Ring
Courtesy of CHRYSLER GROUP, LLC
The CKP sensor O-ring (1) can be reused if not damaged.