Injector(S), Fuel: Installation: 5.7L
WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - PLIERS |
| 2 - INJECTOR CLIP |
| 3 - FUEL INJECTOR - TYPICAL |
| 4 - FUEL RAIL - TYPICAL |
NOTE:
If the same fuel injector is to be reinstalled, install new O-rings.
NOTE:
Apply a small amount of clean engine oil to each injector O-ring. This will aid in the installation.
- Install the fuel injector (3) into the fuel rail (4) using a side to side motion while pushing injector into the fuel rail assembly.
- Using suitable pliers (1), install the fuel injector retaining clip (2).
- Install the fuel rail assembly. Refer to RAIL, FUEL, INSTALLATION .
- Start the engine and check for fuel leaks.