Diagnostic Test

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.

CHECK FOR AN ACTIVE DTC
1. Turn the ignition on.
2. Turn the Park Lamps on.
3. With the scan tool, read the Body Control Module (BCM) DTCs and record on the repair order.
  Is the DTC active?
  
  Yes
  - Go To 2
  No
  - The condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension. If no problems are found, test complete.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
CHECK THE LEFT REAR PARK LAMP
1. Turn the Park Lamps off.
2. Turn the ignition off.
3. Disconnect the Left Rear Tail Lamp Assembly harness connector.
4. Turn the ignition on.
5. Turn the Park Lamps on.
6. With the scan tool, read the BCM DTCs.
  Is the DTC active?
  
  Yes
  - Replace the Left Rear Park Lamp Bulb in accordance with the Service Information.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Go To 3
CHECK THE (L71) LEFT FRONT PARK LAMP DRIVER CIRCUIT FOR A SHORT TO GROUND
1. Turn the ignition off.
2. Disconnect the BCM C6/F harness connector.
3. Measure the resistance between ground and the (L71) Left Rear Park Lamp Driver circuit at the Left Rear Tail Lamp Assembly harness connector.
  Is the resistance below 3.0 Ohms?
  
  Yes
  - Repair the short to ground in the (L71) Left Rear Park Lamp Driver circuit.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Replace the Body Control Module (BCM) in accordance with the Service Information. Refer to MODULE, BODY CONTROL, REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .