Diagnostic Test

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.

CHECK FOR AN ACTIVE DTC
1. Turn the ignition on.
2. Turn the Right Turn Signal on for at least 16 seconds.
3. With the scan tool, read the Body Control Module (BCM) DTCs and record on the repair order.
  Is the DTC active?
  
  Yes
  - Go To 2
  No
  - The condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension. If no problems are found, test complete.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
CHECK THE FRONT RIGHT TURN SIGNAL
1. Turn the ignition off.
2. Disconnect the Right Front Lamp Assembly harness connector.
3. Turn the ignition on.
4. Turn the Right Turn Signal on.
5. With the scan tool, read the BCM DTCs.
  Is the DTC active?
  
  Yes
  - Go To 3
  No
  - Replace the Right Front Turn Lamp Bulb in accordance with the Service Information. Refer to UNIT, FRONT LAMP, REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
CHECK THE (L60) RIGHT FRONT TURN LAMP DRIVER CIRCUIT FOR A SHORT TO GROUND
1. Turn the ignition off.
2. Disconnect the BCM C1/A harness connector.
3. Check for continuity between ground and the (L60) Right Front Turn Lamp Driver circuit at the Right Front Lamp Assembly harness connector.
  Is there continuity between ground and the (L60) Right Front Turn Lamp Driver circuit?
  
  Yes
  - Repair the short to ground in the (L60) Right Front Turn Lamp Driver circuit.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Replace the Body Control Module (BCM) in accordance with the Service Information. Refer to MODULE, BODY CONTROL, REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .