LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2015 >> Durango SXT, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 125 (Tires & Wheels (Service Information)) >> Wheels >> Stud, Wheel >> Installation >> Rear Wheel Stud

Rear Wheel Stud

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the three washers onto the stud, then install the lug nut with the flat side of the nut against the washers.
  2. Tighten the lug nut until the stud is pulled into the hub flange. Verify that the stud is properly seated into the flange.
  3. Remove the lug nut and washers.
  4. Install a new bearing into the knuckle and install the hub. Refer to HUB AND BEARING, INSTALLATION .
  5. Install the wheel and tire assembly, use new lug nut on stud or studs that were replaced. Refer to WHEELS, STANDARD PROCEDURE .
  6. Remove the support and lower vehicle.
scientia non olet · About LEMON Manuals