Section 124 (Starting System (Service Information)): Starter: Removal: 3.6L

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect and isolate the negative battery cable.
Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .

Fig 1: Left Engine Mounts Heat Shield
Courtesy of CHRYSLER GROUP, LLC
Remove the left engine mounts heat shield.

Fig 2: Starter Solenoid Heat Shield
Courtesy of CHRYSLER GROUP, LLC
Remove the starter solenoid heat shield. Only loosen the bolt half way to remove the shield.

Fig 3: Starter Solenoid Electrical Connector, Solenoid Stud, Starter Mounting Bolts & Starter Assembly
Courtesy of CHRYSLER GROUP, LLC
Disconnect the starter solenoid electrical connector (1) from the starter solenoid terminal.
Remove the battery cable nut and battery cable from the solenoid stud (2).
Remove bolts (4) and the starter assembly (3).